en
My Requests
Following
I'D LIKE TO CHAT WITH A REPRESENTATIVE
I'D LIKE TO SUBMIT A SUPPORT REQUEST
Submit a Request
Contact Us
Is your question unavailable?
Chat with a Representative
Submit a Request
Attachments:

Logo

2Wire 2701HG-G Modem Setup

Please Note: We recommend that you are directly connected from your computer to your modem during the setup

2Wire Firmware

If your modem says 2Wire in the top left corner, follow this guide.

  1. Open a web browser and go to the address http://192.168.2.1.
  2. Click on the Broadband Link tab.
  3. Under the Broadband Network section, make sure the Connection Type is PPPoE.
  4. Enter your DSL username and DSL password (confirm password as well).
  5. Click on Save.

Bell Firmware

 If your modem says Bell in the top left corner, follow this guide.

  1. Open a web browser and go to the address http://192.168.2.1.
  2. Click on the Settings tab.
  3. Under the Internet section, click on Link Configuration.
  4. Enter your DSL username (User ID) and DSL password (confirm password as well).
  5. Click on Save.
  6. For wireless, click on the LAN section and then click on Wireless.
  7. Make sure Enable Wireless Interface is checked.
  8. Enter the Network Name (SSID).  SSID broadcast should be enabled.  
  9. Wireless security should be enabled.
  10. Authentication type should be set to WPA2-PSK.
  11. Use the default encryption key as shown OR create your own.
  12. Save settings.

Refer to the link below for screenshots and other 2Wire firmwares.

2Wire

Have more questions? Submit a request
Powered by Zendesk